User Guide

204 Chapter 5 Configuring groups and profiles
320818-A
When you first create the profile, you are prompted to enter the following
parameters:
• client filter name — the name of the predefined client filter that determines
whether the Nortel SNAS 4050 will apply this extended profile to the user. To
view available filters, press TAB at the prompt. You can later change the filter
referenced by the profile by using the
filter command on the Extended
Profile menu.
• VLAN — the name of the VLAN to which the Nortel SNAS 4050 will assign
users with this profile. You can later change the VLAN assignment for the
profile by using the
vlan command on the Extended Profile menu.
The Extended Profile menu displays.
The Extended Profile
menu includes the following options:
Note: If you ran the quick setup wizard during initial setup, two
extended profiles have been created: profile ID 1 associated with client
filter
tg_failed, and profile ID 2 associated with client filter
tg_passed.
/cfg/domain 1/aaa/group #/extend #
followed by:
filter <name>
Specifies the predefined client filter that determines
whether the Nortel SNAS 4050 will apply this extended
profile to the user. If the user’s TunnelGuard check
result matches the filter’s criteria, the Nortel
SNAS 4050 will apply the extended profile. To view
available filters, press TAB following the
filter
command.
• name is a string that must be unique in the domain.
For information about configuring client filters, see
“Configuring client filters using the CLI” on page 201.
vlan <name>
Specifies the VLAN to which the Nortel SNAS 4050 will
assign users with this profile.
•
name is a string that must be unique in the domain.