User Guide

Chapter 6 Configuring authentication 257
Nortel Secure Network Access Switch 4050 User Guide
del <index number>
Removes the specified LDAP server from the current
configuration. The index numbers of the remaining
entries adjust accordingly.
To view the index numbers of all configured LDAP
servers, use the list command.
add <IPaddr> <port>
Adds an LDAP server to the configuration. You are
prompted to enter the following information:
• IPaddr — the IP address of the authentication
server
•
port — the TCP port number used for LDAP
authentication. The default is 389.
The system automatically assigns the next available
index number to the server.
Note: The default TCP port number used by the LDAP
protocol is 389. If LDAPS is enabled, change the port
number to 636.
insert <index number>
<IPaddr>
Inserts a server at a particular position in the list of
LDAP servers in the configuration.
•
index number — the index number you want
the server to have
•
IPaddr — the IP address of the server you are
adding
The index number you specify must be in use. The
index numbers of existing servers with this index
number and higher are incremented by 1.
move <index number>
<new index number>
Moves a server up or down the list of LDAP servers in
the configuration.
•
index number — the original index number of
the server you want to move
•
new index number — the index number
representing the new position of the server in the
list
The index numbers of the remaining entries adjust
accordingly.
/cfg/domain 1/aaa/auth #/ldap/servers
followed by: