User Guide

298 Chapter 6 Configuring authentication
320818-A
5 Click Apply on the toolbar to send the current changes to the Nortel
SNAS 4050. Click Commit on the toolbar to save the changes permanently.
Next steps
1 Configure additional authentication methods, if desired (see “Configuring
RADIUS authentication using the SREM” on page 271 or “Configuring local
database authentication using the SREM” on page 298).
2 Set the authentication order (see “Specifying authentication fallback order
using the SREM” on page 314).
3 Commit the changes (see “Saving authentication settings” on page 316).
Configuring local database authentication using the SREM
To configure the Nortel SNAS 4050 to use a local database for authentication,
perform the following steps:
1 Add the Local method to the domain and create the local database (see
“Adding the Local method” on page 299).
2 Populate the database (see “Populating the database” on page 301).
3 Modify the local database settings, if desired (see “Modifying Local database
configuration” on page 305).
4 Export the local database, if desired (see “Exporting the database” on
page 312).
Note: If you ran the quick setup wizard during initial setup, Local
database authentication has been created with authentication ID = 1. The
database contains one test user (
tg), who belongs to a group called
tunnelguard. To continue configuring the local database, go to
“Populating the database” on page 301.