User Guide

Chapter 6 Configuring authentication 313
Nortel Secure Network Access Switch 4050 User Guide
2 Enter the export information in the applicable fields.
Table 55 describes the Export Local User Database fields.
3 Click Apply on the toolbar to export the specified local user database.
Next steps
1 Configure additional authentication methods, if desired (see “Configuring
RADIUS authentication using the SREM” on page 271 or “Configuring
LDAP authentication using the SREM” on page 282).
2 Set the authentication order (see “Specifying authentication fallback order
using the SREM” on page 314).
3 Commit the changes (see “Saving authentication settings” on page 316).
Table 55
Export Local User Database fields
Field Description
Protocol Specifies the export protocol. Options are:
•ftp
•tftp
•sftp
• scp
The default is ftp.
Host Specifies the host name or IP address of the server.
Filename Specifies the name of the database file on the server.
Pass Phrase/Key Specifies the password key for user password protection.
For a database file whose passwords were protected with a
key when the file was exported, the key you must provide is
the same as the password key provided at the time of
export. If the file is not protected with a key, enter any
characters (a minimum of four) when prompted.
Username For FTP, SFTP, and SCP, the user name and password to
access the file exchange server.
Password For FTP, SFTP, and SCP, the user name and password to
access the file exchange server.