User Guide

316 Chapter 6 Configuring authentication
320818-A
3 Rearrange the list so that the methods appear in the desired order.
a Click on a method to select it.
b Using the up and down arrows, move the method to the desired position
in the list.
c Repeat for the other methods until the list is in the desired order.
4 Click Apply on the toolbar to send the current changes to the Nortel
SNAS 4050. Click Commit on the toolbar to save the changes permanently.
Saving authentication settings
To save changes to the current configuration at any time, perform the following
steps:
1 Send changes to the Nortel SNAS 4050 using one of the following
procedures:
a Click Apply on the toolbar to immediately accept all changes.
b Click the Change Manager icon in the bottom right corner to view and
confirm the list of change current changes.
The Change Manager allows you to review or remove specific changes
before clicking Apply All.
2 Click Diff to view pending changes on the Nortel SNAS 4050.
3 Do one of the following to implement or remove pending changes:
a To implement the changes and alter the configuration permanently, click
Commit on the toolbar.
b To discard the changes and revert to the previous configuration, click
Revert on the toolbar.
Note: A confirmation dialog may appear before entering the Change
Manager screen, asking if you want to review the changes and apply
them to the device. If this dialog does appear, click No to continue
viewing the Change Manager.