User Guide

42 Chapter 1 Overview
320818-A
Figure 2 illustrates a two-armed configuration.
Figure 2
Two-armed configuration
Nortel SNA configuration and management tools
You can use a number of device and network management tools to configure the
Nortel SNAS 4050 and manage the Nortel SNA solution:
• Command Line Interface (CLI)
You must use the CLI to perform initial setup on the Nortel SNAS 4050 and to
set up the Secure Shell (SSH) connection between the Nortel SNAS 4050 and
the network access devices, and between the Nortel SNAS 4050 and the GUI
management tool. You can then continue to use the CLI to configure and
manage the Nortel SNAS 4050, or you can use the GUI.
The configuration chapters in this User Guide describe the specific CLI
commands used to configure the Nortel SNAS 4050. For general information
about using the CLI, see Chapter 16, “The Command Line Interface,” on
page 769.
Internet
Management
station
Endpoint
device
Default gateway
192.168.128.1
NSNAS
1
Client portal interface (2)
192.168.128.11 (RIP 2 [host])
192.168.128.100 (pVIP [portal])
Management interface (1)
10.1.0.11 (MIP [management])
10.1.0.12 (RIP 1 [host])
2
Network access device