User Guide

Chapter 2 Initial setup 55
Nortel Secure Network Access Switch 4050 User Guide
7 Specify whether you are setting up a one-armed or a two-armed configuration.
If you are setting up a one-armed configuration, press Enter to accept the
default value (
no). Go to step 8.
If you are setting up a two-armed configuration, enter
yes. Go to step 9.
8 Specify the default gateway IP address.
The default gateway is the IP address of the interface on the core router that
will be used if no other interface is specified. The default gateway IP address
must be within the same network address range as the RIP.
Go to step 10.
9 Configure the interface for client portal traffic (Interface 2).
a Specify a port number for the client portal interface. This port will be
assigned to Interface 2. The port number must not be the same as the port
number for the management interface (Interface 1).
b Specify the RIP for Interface 2.
c Specify the network mask for the RIP on Interface 2.
d If the core router attaches VLAN tag IDs to incoming packets, specify the
VLAN tag ID used.
e Specify the default gateway IP address for Interface 2. The default
gateway is the IP address of the interface on the core router that will be
Setup a two armed configuration (yes/no) [no]:
Enter default gateway IP address (or blank to skip):
<IPaddr>