User Guide

58 Chapter 2 Initial setup
320818-A
16 Change the admin user password, if desired.
Make sure you remember the password you define for the admin user. You
will need to provide the correct admin user password when logging in to the
Nortel SNAS 4050 (or the Nortel SNAS 4050 cluster) for configuration
purposes.
17 Run the Nortel SNAS 4050 quick setup wizard. This creates all the settings
required to enable a fully functional portal, which you can customize later
(see “Configuring the domain” on page 117).
For information about the default settings created by the wizard, see “Settings
created by the quick setup wizard” on page 60.
a Start the quick setup wizard.
b Specify the pVIP of the Nortel SNAS 4050 device.
c Specify a name for the Nortel SNAS 4050 domain.
d Specify any domain names you wish to add to the DNS search list, as a
convenience to clients. If the domain name is in the DNS search list,
clients can use a shortened form of the domain name in the address fields
on the Nortel SNAS 4050 portal.
Enter a password for the "admin" user:
Re-enter to confirm:
Run NSNAS quick setup wizard [yes]: yes
Creating default networks under /cfg/domain 1/aaa/
network
Enter NSNAS Portal Virtual IP address(pvip): <IPaddr>
Enter NSNAS Domain name: <name>
Enter comma separated DNS search list
(eg company.com,intranet.company.com):