User Guide

64 Chapter 2 Initial setup
320818-A
In a one-armed configuration, you are specifying the port you want to use for
all network connectivity, since Interface 1 is used for both management traffic
(Nortel SNAS 4050 management and connections to intranet resources) and
client portal traffic (traffic between the TunnelGuard applet on the client and
the portal).
In a two-armed configuration, you are specifying the port you want to use for
Nortel SNAS 4050 management traffic.
4 Specify the RIP for this device. This IP address will be assigned to
Interface 1.
The RIP must be unique on the network and must be within the same subnet
as the MIP.
5 Specify the network mask for the RIP on Interface 1.
6 If the core router attaches VLAN tag IDs to incoming packets, specify the
VLAN tag ID used.
7 Specify whether you are setting up a one-armed or a two-armed configuration.
If you are setting up a one-armed configuration, press Enter to accept the
default value (
no). Go to step 9.
If you are setting up a two-armed configuration, enter
yes. Go to step 8.
Note: For consistency, Nortel recommends that you specify the same
port number for the management interface port on all Nortel SNAS 4050
devices in the cluster.
Enter IP address for this machine (on management
interface): <IPaddr>
Enter network mask [255.255.255.0]: <mask>
Enter VLAN tag id (or zero for no VLAN) [0]:
Setup a two armed configuration (yes/no) [no]: