User Guide

Chapter 2 Initial setup 65
Nortel Secure Network Access Switch 4050 User Guide
8 Configure the interface for client portal traffic (Interface 2).
a Specify a port number for the client portal interface. This port will be
assigned to Interface 2. The port number must not be the same as the port
number for the management interface (Interface 1).
b Specify the RIP for Interface 2.
c Specify the network mask for the RIP on Interface 2.
d If the core router attaches VLAN tag IDs to incoming packets, specify the
VLAN tag ID used.
9 Specify the MIP of the existing cluster.
10 Specify the default gateway IP address for Interface 2. The default gateway is
the IP address of the interface on the core router that will be used if no other
interface is specified. The default gateway IP address on Interface 2 must be
within the same subnet as the RIP for Interface 2.
11 Provide the correct admin user password configured for the existing cluster.
Enter port number for the traffic interface [1-4]:
<port>
Enter IP address for this machine (on traffic interface):
<IPaddr>
Enter network mask [255.255.255.0]: <mask>
Enter VLAN tag id (or zero for no VLAN) [0]:
The system is initialized by connecting to the management
server on an existing iSD, which must be operational and
initialized.
Enter the Management IP (MIP) address: <IPaddr>
Enter default gateway IP address (on the traffic
interface): <IPaddr>
Enter the existing admin user password: <password>