User Guide

66 Chapter 2 Initial setup

320818-A

12 Wait while the Setup utility finishes processing. When processing is complete,

you will see

Setup successful.

The new Nortel SNAS 4050 automatically picks up all other required

configuration data from the existing Nortel SNAS 4050 in the cluster. After a

short while, you receive the

Next steps

1 To enable the SREM connection to the Nortel SNAS 4050:

a Use the

/cfg/sys/adm/ssh on command to enable SSH access to the

Nortel SNAS 4050 (for more information, see “Configuring

administrative settings using the CLI” on page 483).

b Use the

/cfg/sys/adm/srsadmin ena command to enable

TunnelGuard SRS administration (for more information, see “Enabling

TunnelGuard SRS administration using the CLI” on page 485 or

“Configuring SRS control settings using the SREM” on page 547).

From this point on, you can configure the Nortel SNAS 4050 using either the

CLI or the SREM.

2 To enable remote management using Telnet, use the

/cfg/sys/adm/

telnet on

command to enable Telnet access to the Nortel SNAS 4050 (for

more information, see “Configuring administrative settings using the CLI” on

page 483).

Note: For greater security, you may want to restrict access to the Nortel

SNAS 4050 to those machines specified in an Access List. In this case,

ensure that you add an IP address for the SREM to the Access List. For

more information about using the Access List to control Telnet and SSH

access, see “Configuring the Access List using the CLI” on page 474 or

“Configuring the access list using the SREM” on page 525.

Setup successful.