User Guide

68 Chapter 2 Initial setup
320818-A
Applying and saving the configuration using the CLI
If you have not already done so after each sequence of configuration steps,
confirm your changes using the
apply command.
To view your configuration on the screen, for copy and paste into a text file, use
the following command:
/cfg/dump
To save your configuration to a TFTP, FTP, SCP, or SFTP server, use the following
command:
/cfg/ptcfg
For more information, see “Backing up or restoring the configuration using
the CLI” on page 730.
Applying and saving the configuration using the SREM
In the SREM, there are two steps to saving configuration changes, described
below:
1 Click Apply after each change, to send the change to the Nortel SNAS 4050
device.
Changes that have been applied are not yet permanent. To cancel changes that
have been applied, click Revert to remove all unconfirmed changes.
2 Click Commit once your changes are complete, to change the permanent
configuration on the Nortel SNAS 4050.
Committed changes take effect immediately.