User Guide
Chapter 3 Managing the network access devices 75
Nortel Secure Network Access Switch 4050 User Guide
Adding a network access device using the CLI
You can add a network access device to the configuration in two ways. You must
repeat the steps for each switch that you want to add to the domain configuration.
• “Using the quick switch setup wizard” on page 75
• “Manually adding a switch” on page 78
Using the quick switch setup wizard
To add a network access device to the Nortel SNAS 4050 domain using the quick
switch setup wizard, use the following command:
/cfg/domain 1/quick
You can later modify all settings created by the quick switch setup wizard (see
“Configuring the network access devices using the CLI” on page 80).
1 Launch the quick switch setup wizard.
2 Specify the type of switch. Valid options are:
•
ERS8300 (for an Ethernet Routing Switch 8300)
•
ERS5500 or ERS55 (for an Ethernet Routing Switch 5510, 5520, or
5530).
The default is
ERS8300.
Note: The input is case sensitive.
3 Specify the IP address of the network access device.
>> Main# cfg/domain 1/quick
Enter the type of the switch (ERS8300/ERS5500) [ERS8300]
IP address of Switch: <IPaddr>