User Guide

Chapter 3 Managing the network access devices 79
Nortel Secure Network Access Switch 4050 User Guide
Figure 4 Adding a switch manually
Deleting a network access device using the CLI
To remove a network access device from the domain configuration, first disable
the switch then delete it. Use the following commands:
/cfg/domain #/switch #/dis
/cfg/domain #/switch #/delete
The disable and delete commands log out all clients connected through the
switch.
>> Domain 1# switch 1
Creating Switch 3
Enter name of the switch: Switch1_ERS8300
Enter the type of the switch (ERS8300/ERS5500): ERS8300
Enter IP address of the switch: <IPaddr>
NSNA communication port[5000]:
Enter VLAN Id of the Red VLAN: <VLAN ID>
Entering: SSH Key menu
Enter username: rwa
Leaving: SSH Key menu
----------------------------------------------------------
[Switch 3 Menu]
name - Set Switch name
type - Set Type of the switch
ip - Set IP address
port - Set NSNA communication port
hlthchk - Health check intervals for switch
vlan - Vlan menu
rvid - Set Red VLAN Id
sshkey - SSH Key menu
reset - Reset all the ports on a switch
ena - Enable switch
dis - Disable switch
delete - Remove Switch
Error: Failed to retrieve host key
>> Switch 3#..