Manualshelf

Network Card User Guide

ManualsBrandsNortel Networks ManualsNetwork Card5100
141142143144145146147148149150
Nortel Switched Firewall Browser-Based Interface Users Guide
Browser-Based Interface forms reference 141
216383-D October 2005
APC UPS form
Use the Administration/APC UPS form to configure settings for American Power Corporation
Uninterrupted Power Supply (APC UPS) (see Administration/APC UPS form).
Figure 107 Administration/APC UPS form
Fields and buttons on the Administration/APC/UPS form are as follows:
Status provides a list with the following two selections:
Enabled enables the UPS monitor.
Disabled disables the UPS monitor.
UPS Type provides a list to set the UPS type from the following selections:
usb (USB port)
snmp (Ethernet through SNMP)
SNMP Host provides an entry field to specify the SNMP Host IP address for connection.
TIP: Use dotted decimal notation.
SNMP Port provides an entry field to specify the SNMP port for connection.
SNMP Community provides an entry field to set the SNMP community for connection.
Battery Level provides a list to specify the battery level, in percentage, below which the
Firewall shuts down. The list represents a range from 0 to 100 percent.
Master IP Address provides an entry field to specify the UPS Master IP address. TIP: Use
dotted decimal notation.