Remote Gateway Quick Start Guide

10 Configuration
P0918963
Standard 1.1
Note: If, at any time while working with the telephone set menu, you make a
mistake, you can return to the previous level in the menu system by pressing the
Release (Rls, R, or Goodbye depending on your telephone set) key once.
Configuring the Remote Gateway 911x series unit
After installing the Remote Gateway 911x series unit and powering up:
1 Press the Release key four times within three seconds to access the telephone
menu.
Result: The telephone display prompts you for a user name:
2 Enter 48378 (GUEST) on the telephone keypad and then press Hold.
Result: The telephone display prompts you for a password:
3 Enter 48378123 (GUEST123), the default password, or the current password
if you have customized the password and then press Hold.
Result: The telephone display prompts you to display the Remote Gateway
911x series unit’s IP parameters:
4 Use the information provided on the Remote Gateway 911x series telephone
menu — Configuration Values form to respond to each telephone display
prompt and make the appropriate menu selection. Refer to “Telephone menu
keys” on page 9 for further assistance.
Contact your System Administrator if you experience any problems configuring
the Remote Gateway 911x series unit.
ASTERISK * period (.), delimiter for IP addresses
POUND # backspace with delete
Enter User Name
Press the Rls key to exit.
Enter Password
Press the Rls key to exit.
Display Local IP?
[1-Yes 2-No]
Key name Key label 911x telephone menu key function