Remote Gateway Quick Start Guide

9
Remote Gateway 911x Series Quick Start Guide
Standard 1.1
Configuration
You can configure the Remote Gateway 911x series unit through the telephone
set. The procedure is the same for either the Remote Gateway 9110 circuit card or
9115 unit. Before you begin, your System Administrator must supply you with a
completed Remote Gateway 911x series telephone menu — Configuration Values
form. Use the information provided on this form to configure the Remote
Gateway 911x series unit.
Note: The procedure to configure the Remote Gateway 911x series unit
establishes a connection between the unit and the RLC. The System Administrator
can then configure the other parameters through the network connection.
If your System Administrator has already configured your unit, you do not need to
complete the configuration procedure.
Telephone menu keys
When working with the Remote Gateway 9100 Series telephone menu, use the
following table as a guide for the proper keys to use:
Key name Key label 911x telephone menu key function
DIGIT 1, 2, 3, 4, 5, 6, 7, 8, 9, 0 user name/password entry, numeric entry
ALPHA 2, 3, 4, 5, 6, 7, 8, 9 user name/password entry
YES 1 request menu, enable feature
NO 2 skip menu, disable feature
RELEASE Rls, R, Goodbye
(depending on your
telephone set)
enter configuration mode, return to
previous menu, exit system
ENTER Hold accept selection, move to next menu
prompt