Network Router User Manual

303532-A Rev 00
3-1
Chapter 3
Customizing L2TP Services
When you enable L2TP, default values are in effect for most parameters (see
parameter descriptions in Appendix A, “L2TP Parameters”). You may want to
change some of these values, depending on the requirements of your network.
This chapter includes the following information:
Topic Page
Modifying the L2TP Protocol Configuration
3-2
Modifying RADIUS Server Information 3-3
Changing the LNS System Name 3-4
Modifying the Number of L2TP Sessions Permitted 3-5
Keeping the Remote User’s Domain Name 3-6
Changing the Domain Name Delimiter 3-7
Enabling Tunnel Authentication 3-8
Modifying L2TP IP Interface Addresses 3-9
Disabling RIP 3-10
Disabling L2TP 3-10
Deleting L2TP from a PPP Interface 3-11
Deleting L2TP from a Frame Relay Interface 3-12
Deleting L2TP from an ATM Interface 3-13