Network Router User Manual

Configuring L2TP Services
3-10
303532-A Rev 00
Disabling RIP
RIP is enabled on the LNS by default so that the LNS can learn routes from the
remote dial-in router. If the LNS does not require RIP support, you can disable it.
To disable RIP, complete the following tasks:
Disabling L2TP
To disable L2TP on a slot, complete the following tasks:
Site Manager Procedure
You do this System responds
1. In the Configuration Manager window,
choose
Protocols
.
The Protocols menu opens.
2. Choose
IP
. The IP menu opens.
3. Choose
L2TP
. The L2TP menu opens.
4. Choose
L2TP IP Interface
. The L2TP IP Interface List window opens.
5. Select an LNS entry from the list.
6. Set the
RIP Enable
parameter to
Disable
.
Click on
Help
or see the parameter
description on page A-12
.
7. Click on
Done
. You return to the Configuration Manager
window.
Site Manager Procedure
You do this System responds
1. In the Configuration Manager window,
choose
Protocols
.
The Protocols menu opens.
2. Choose
IP
. The IP menu opens.
3. Choose
L2TP
. The L2TP menu opens.
4. Choose
L2TP Configuration
. The L2TP Configuration List window
opens.
5. Select an LNS entry from the list.
(continued)