Manual
- Press button 1 to validate the delay time. The display shows “ A.dEL“ again.
Example:
You want to have a temperature alarm-monitoring of a greenhouse. The alarm should start
when the temperature rises above 50°C or falls below 15°C. Therefore your settings will be
50°C for the maximum alarm-value “AL.HI“ and 15°C for the minimum alarm-value “AL.Lo“.
The alarm will be starting after the temperature rises above 50°C and stays above 50°C for the
entered delay time or after it had been falling below 15°C and stays below 15°C for the ente
red
delay time.
Please note that the alarm-outputs are inverted! This means, that the output will be
active
when there is no alarm!
Now you finished configuring the alarm adjustment of your device. Press button 1 to finish the
adjustment and to switch over to display the measuring value.
6 Offset- and slope-adjustment
The offset and slope-adjustment function can be used for compensating the tolerance of
the used sensor, resp. for vernier adjustment of the used transducer / transmitter.
Please note:
The storage of a configuration value will be occur by switching to the next configuration
value (via button 1).
When configuration is active and no button is pressed for more than 60 seconds the
configuration will be cancelled. Stored changes will not be lost!
Hint:
The buttons 2 and 3 are featured with a ‘roll-function‘. When pressing the button once the
v
alu
e will be raised (button 2) by one or lowered (button 3) by one.
When holding the button pressed for longer than 1 second the value starts counting up or
down, the counting speed will be raised after a short period of time.
- Turn on the device and wait after it finished its built-in segment test.
- Press button 3 > 2 seconds. The device will display “ OFFS“ (Offset).
- Use button 2 and button 3 for setting the desired zero point offset-value.
The input of the offset value are in digits. The value that had been set will be subtract
ed from t
he
measured value (see below for further information).
Button2
Button1
Button3
1010 West Bagley Road, Berea, Ohio 44017 P 440.243.0888 F 440.243.3472 www.noshok.com
12