Use and Care Guide
ENGLISH
10
CO
2
& TAP TOWER INSTALLATION
You must read and understand the steps below for the CO
2
assembly before installation.
When you purchase the rst keg of beer, you must also have your CO
2
cylinder lled at
your local supplier.
CO
2
tanks can be relled at locations such as welding supply shops,
party stores, or wherever kegs are purchased.
(cont. on next page)
STEP 1
Make sure white nylon High Pressure
Washer (already installed) is attached
to
CO
2
Double Regulator.
STEP 2
Use Wrench to attach Double
Regulator to
CO
2
Tank connector.
STEP 3
Remove spring from inside the Keg Coupler.
If spring is not present, go on to Step 4.
STEP 4
Make sure Backow Stopper is inserted
in the Keg Coupler (the Backow Stopper
goes in with rounded side down).
STEP 5
After the Backow Stopper has been
inserted, remove the three parts above.