Use and Care Guide

ENGLISH
11
STEP 6
The CO
2
Rubber
Directional
Washer goes
back into the
Keg Coupler.
STEP 7
Connect the
CO
2
line from
the Double
Regulator to the
Keg Coupler.
STEP 11
After the Tap Tower has been placed
on the KEGORATOR™ and the hose
line feeds through the bottom, attach
the wing nut to the Keg Coupler.
STEP 8
Place the Beer Tower Washer (#5) over
the hole. Place the Tap Tower on the
KEGORATOR™ and feed the hose line through
the hole in the top of the KEGORATOR™.
STEP 9
Make sure the notches in the Tap Tower t into
the holes in the top of the KEGORATOR™. Tighten
the Tap Tower by twisting until it locks in place.
STEP 10
Place Coupler Washer (#3)on
top of the Keg Coupler.