User manual

Problem Possible cause Solution
A rectangular symbol is
shown instead of numbers on
the Temperature Display.
Temperature sensor prob-
lem.
Contact the nearest Author-
ized Service Centre (the cool-
ing system will continue to
keep food products cold, but
temperature adjustment will
not be possible).
The lamp does not work. The lamp is in stand-by. Close and open the door.
The lamp is defective. Contact the nearest Author-
ized Service Centre.
The compressor operates
continually.
Temperature is set incorrect-
ly.
Refer to "Operation" chapter.
Many food products to be
frozen were put in at the
same time.
Wait a few hours and then
check the temperature again.
The room temperature is too
high.
Refer to climate class chart
on the rating plate.
Food products placed in the
appliance were too warm.
Allow food products to cool
to room temperature before
storing.
The FastFreeze function is
switched on.
Refer to "FastFreeze func-
tion".
The Shopping function is
switched on.
Refer to "Shopping function".
There is too much frost and
ice.
The door is not closed cor-
rectly or the gasket is de-
formed/dirty.
Refer to "Closing the door".
The water drainage plug is
not correctly positioned.
Position the water drainage
plug in the correct way.
Food products are not wrap-
ped properly.
Wrap the food products bet-
ter.
Temperature is set incorrect-
ly.
Refer to "Operation" chapter.
The compressor does not
start immediately after press-
ing the FastFreeze,Shopping
or after changing the temper-
ature.
This is normal, no error has
occurred.
The compressor starts after a
period of time.
12