User manual

11 ENGLISH
8.2 Customer Service
If your appliance is still not working
properly after making the above checks,
contact the nearest service centre.
To obtain fast service, it is essential that
when you apply for it you specify the
model and serial number of your
appliance which can be found either on
the guarantee certicate or on the rating
plate located on the external right side
of the appliance.
9. INSTALLATION
WARNING!
Refer to Safety chapters.
9.1 Positioning
CAUTION!
If you are discarding an old appli-
ance that has a lock or catch on
the lid, you must ensure that it is
made unusable to prevent young
children being trapped inside.
This appliance should be installed in
a dry, well ventilated indoor where the
ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
Climate class Ambient temperature
SN +10ºC to +32ºC
N +16ºC to +32ºC
ST +16ºC to +38ºC
T +16ºC to +43ºC
Some functional problems might
occur for some types of models
when operating outside of that
range. The correct operation can
only be guaranteed within the
specied temperature range. If
you have any doubts regarding
where to install the appliance,
please turn to the vendor, to our
customer service or to the nearest
Service Centre
The appliance shall have the
plug accessible after instal
-
lation.
9.2 Electrical connection
• Before plugging in, ensure that the volt-
age and frequency shown on the rating
plate correspond to your domestic
power supply.
• The appliance must be earthed. The
power supply cable plug is provided
with a contact for this purpose. If the
domestic power supply socket is not
earthed, connect the appliance to a
separate earth in compliance with cur
-
rent regulations, consulting a qualied
electrician.
• The manufacturer declines all responsi
-
bility if the above safety precautions are
not observed.
• This appliance complies with the E.E.C.
Directives.
9.3 Ventilation requirements
The airow behind the appliance must
be sufcient.
1. Put the freezer in horizontal position
on a rm surface. The cabinet must
be on all four feet.
2. Make sure that the clearance be-
tween the appliance and rear wall is
5 cm.
3. Make sure that the clearance be-
tween the appliance and the sides is
5 cm.