Owner manual

it will display as follows to indicate the measurement is being undertaken:

----Te st i n g ----

1 2 3 4 5 6 7 8. . .

Note:In view of different technical parameters in various brand cables, the

user should apply the tester dynamic calibration function before length

measurement (Refer to the details herein).

Test Result 1: Short circuit (SHORT)

It will display as follows if there is any short circuit in cable or terminal:(12

short circuit in the sample)

S h o r t :

1 2

Test Result 6: Open circuit in the middle of cable

It will display wiring diagram (WIREMAP) as follows if there is an open

circuit in the middle of the cable:

W i r e m a p : fa i l

R : 1 2 3 4 5 6 78 i d 1

I i x i i i ii

M : 1 2 3 4 5 6 78

"|” line "3" pin location displays "x", it indicates an open circuit in the middle of

"3" pin cable. (The open circuit should be located within 10%-90%cable length

if it is measured from the near-end plug.) For further locating open circuit, the

function (PAIR & LENGTH) of the tester could used as detailed hereinafter.

Your excellent helper in cable test!