Use and Care Manual

USE AND CARE
FIG. 14
HO0352
- 5 -
CONTROL KNOBS
Right knob controls light and left knob controls blower.
Light: Rotate light knob CLOCKWISE to turn ON the light. Rotate knob
COUNTERCLOCKWISE to turn light OFF.
Blower: Rotate blower knob CLOCKWISE to turn blower ON to LOW
speed. Further CLOCKWISE rotation sets blower on HIGH
speed. Rotate knob fully COUNTERCLOCKWISE (past LOW
speed) to turn fan OFF.
CLEANING
Finish Keep your range hood clean using a mild detergent suitable for
painted surfaces.
The aluminum filter should be cleaned frequently. Use a warm
dishwashing detergent solution.
Clean all-metal filter using a non-phosphate detergent. Discoloration of the
filter may occur if using phosphate detergents, or as a result of local water
conditions - but this will not affect filter performance. This discoloration is
not covered by the warranty. To minimize or prevent discoloration, hand
wash filter using a mild detergent.
FILTER REMOVAL
Remove filter by pulling on its plastic tab.
LIGHT BULB REPLACEMENT
Light bulb (not supplied with hood) should be HALOGEN OR LED, but
always GU10 base. Align the bulb leads with the small indentations located
on the border of the lamp location on hood (see inset in FIG.14), then
install the bulb by placing the bulb leads into their grooves in the socket.
NOTE: Do not fold the plate (grey part in FIG.14) located in the light bulb
housing. Gently push upwards and turn clockwise until secured.
Halogen bulb: Shielded halogen bulb, GU10 base, 50 watts maximum.
LED bulb: 7 watts maximum, GU10 base.
WARNING
Do not touch lamps during or soon after operation. Burns
may occur. In order to prevent the risk of personal injury,
only install shielded halogen lamps. Also, never install a
cool beam, a dichroic lamp, a lamp not suitable for use
in recessed luminaires or identified for use in enclosed
fixtures.
!