User Manual

3. I/O

3.1 Introduction

3.1.1 System Introduction

NUUO provides remote I/O solution for NVRmini/NVRmini 2/Titan NVR by

connecting SCB-C31 with NUUO I/O Box SCB-C24/26/28. Refer to the below

architecture, I/O device is connected directly with I/O Box, and input/output

signal delivered in RS485 format are converted to Ethernet through SCB-C31.

NVRmini/NVRmini 2/Titan NVR can use the signals to do more sophisticated

setup, such as starting recording when input triggered, triggering output as an

event happened, and much more.

3.1.2 HW Installation

SCB-C24/26/28 must work with SCB-C31 (Ethernet-RS485 converter).

Further, the C31 Box cannot be used for POS and converter at the same

time, and one C31 Box can be paired with one NVR unit only. Please

follow the steps below to configure the devices.

Step 1: Check the system switch of SCB-C31 is switched to OFF-OFF position.

Step 2: Connect SCB-C31 with power source.

Step 3: Connect SCB-C31 with internet by RJ45 LAN cable.

Step 4: Connect I/O Box with power source.

Step 5: Connect SCB-C31 and I/O Box with cable, positive connection

(TX+/D+ and DATA+) and negative connection (TX-/D- and DATA-). Take

SCB-C31 with I/O Box SCB-C24 for example as below.