Installation Guide

ASSEMBLY INSTRUCTION

SKU#60/4185, 60/4205, 60/4186, 60/4206

NOTE: Please consult a qualified electrician if you are not certain of the installation or service.

CAUTION: Before starting the installation or service, disconnect the power by turning off the circuit breaker

or by removing the fuse at the fuse box.

1. Carefully unpack the fixture, lay out all parts on a clean surface.

2. Fasten the mounting strap onto the outlet box by using provided 2 outlet box screws.

3. Screw the nipple to the fixture body. Place the tube B over the nipple.

4. Fasten the top end of the rods to the bottom cover using screws. Then insert the bottom end of the rods to the

connections.

5. Place the tube A and top cover over the nipple. Fasten the loop to the nipple.

6. Using two pliers, twist open links at two ends of the chain as shown. Hook one link to the loop and the other link to the

screw collar loop. Close the links. Place a piece of cloth between the pliers jaws and the chain link to prevent

scratching the link finish.

7. Weave fixture wires up through the nipple, through the tube B, through the bottom cover, through the tube A, through

the top cover, through the loop, through the chain, through the ring, through the screw collar loop and through the

canopy and through the nipple on the mounting strap.

8. Tie the ground wires from fixture and from outlet box to the ground screw on the mounting strap. Connect the wire

without writing on it (with raised ribs) from the fixture to the white wire (neutral wire) from the supply circuit.

Connect the wire with writing on it from the fixture to the black wire (live wire) from the supply circuit. Cover the

connections using provided wire connectors. Position wires back inside outlet box.

9. Place the canopy over the nipple all the way to the ceiling and tighten the ring onto the screw collar loop until the

canopy is held firmly against the ceiling.

10. Unscrew the socket rings and socket covers from the sockets. Place the shades and socket covers over the

sockets, refasten the socket rings to secure them.

11. Install the bulbs (Not included). Turn on the power.

A Satco Product

PAGE 1
ASSEMBLY INSTRUCTION SKU#60/4185, 60/4205, 60/4186, 60/4206 NOTE: Please consult a qualified electrician if you are not certain of the installation or service. CAUTION: Before starting the installation or service, disconnect the power by turning off the circuit breaker or by removing the fuse at the fuse box. 1. Carefully unpack the fixture, lay out all parts on a clean surface. 2. Fasten the mounting strap onto the outlet box by using provided 2 outlet box screws. 3.
PAGE 2
INSTRUCCIÓN DE ASAMBLEA SKU#60/4185, 60/4205, 60/4186, 60/4206 NOTE: Por favor, Consulte con un electricista cafificado en caso de que esté seguro de la instalación. CAUCIÓN: Antes de comenzar la instalación, cortar la electricidad mediante apagar el cortacircuitos o quitar el fusible desde la caja de fusible. 1. Desempaquetar cuidadosamente la instalación, disponer todas las piezas sobre una superficie límpia. 2.