Installation Guide

ASSEMBLY INSTRUCTION
SKU# 60/5699, 60/5599
NOTE: Please consult a qualified electrician if you are not certain of the installation or service.
CAUTION: Before starting the installation or service, disconnect the power by turning off the
circuit breaker or by removing the fuse at the fuse box.
1. Carefully unpack the fixture, lay out all parts on a clean surface.
2. Attach the mounting strap to outlet box using the outlet box screws provided.
3. Fasten the loop to the nipple B.
4. Using two pliers twist open the links at the two ends of the chain hook one link to loop and the
other link to the screw collar loop. Close the links. Place a piece of cloth between the pliers jaws and
the chain link to prevent scratching the link finish.
5. Separate the chandelier arms, then adjust the chandelier arms to their proper position.
6. Weave the fixture wires up through the loop, through the chain, through the ring, through the screw
collar loop and through the canopy and through the nipple A on the mounting strap.
7. Tie ground wire from fixture and from outlet box to the ground screw on the mounting strap.
Position wires back inside outlet box. Connect the wire with writing on it from fixture to the black
wire （live wire） from the supply circuit. Connect the wire without writing on it (with raised ribs)
from fixture to the white wire (neutral wire) from the supply circuit. Cover the connections using
provided wire connectors.
8. Place the canopy over the nipple A all the way to ceiling and tighten the ring onto the screw collar
loop until the canopy is held firmly against the ceiling.
9. Unscrew the socket rings from the sockets. Place the shades over sockets, refasten the socket rings to
secure them.
10. Install the bulbs, (Not included). Turn on the power.
A Satco Product