Installation Sheet
FOR YOUR SAFETY
WARNING: BE SURE THE ELECTRICITY TO THE WIRES
YOU ARE WORKING ON IS SHUT OFF; EITHER THE FUSE IS
REMOVED OR THE CIRCUIT BREAKER IS SHUT OFF.
GENERAL
You don’t need special tools to install this xture. Be sure to follow
the steps in the order given. Under no circumstances should
a xture be hung on house electrical wires, nor should a swag
type xture be installed on a ceiling which contains a radiant type
heating system. Read instructions carefully. If you are unclear as to
how to proceed, consult a qualied electrician.
NOTE: Proper wiring is essential for the safe operation of this xture.
FIXTURE ASSEMBLY
Carefully remove the xture from the carton and check that all
parts are included as shown in gure. Be careful not to misplace
any of the screws or parts, which are needed to install this xture.
INSTALLATION
IMPORTANT: Do not attach xture directly to outlet box.
Dimmable with ELV and/or LED compatible wall dimmer switches.
STEP 1: Secure mounting plate (B) to outlet box (A) using
mounting screws (C). See Figure 1. The side of the mounting plate
marked “GND” must face out.
STEP 2: Adjust tube (F) to adjust the power cable and support
cables (G) to the desired hanging height. Cut and discard excess
power cable and support cable (G).
NOTE: Leave 7-10 inches of extra power cable to allow for
electrical connection.
GROUNDING INSTRUCTIONS
STEP 1: Connect the electrical wires as shown in Figure 2, making
sure that all wire connectors are secured. If your outlet has a ground
wire (green or bare copper), connect the xtures ground wire to it.
Otherwise, connect the xture ground wire directly to the mounting
plate (B) using the green screw provided. After wires are connected,
tuck them carefully inside the outlet box.
NEVER CONNECT GROUND WIRE TO BLACK OR WHITE
POWER SUPPLY WIRES.
FINAL ASSEMBLY
STEP 1: Align the xture’s canopy (E) over the mounting plate (B)
and secure with screws (D).
CLEANING
To clean, wipe xture with a soft cloth. Clean glass with a mild
soap. Do not use abrasive materials such as scouring pads or
powders, steel wool or abrasive paper.
ORDERING PARTS
Keep this sheet for future reference, and in case you need to order
replacement parts. Be sure to use exact wording from illustration
when ordering parts.
INSTALLATION AND SAFETY INSTRUCTIONS
ITEM NO: 62-1455, 62-1456,
62-1457, 62-1458
ARTÍCULO Nº: 62-1455, 62-1456, 62-1457, 62-1458
ARTICLE N°: 62-1455, 62-1456, 62-1457, 62-1458
FIGURE 1.
Line art shown may not exactly match the xture enclosed. However,
the installations do apply to this xture.
La ilustración puede no concordar exactamente con la pieza enviada.
Sin embargo, las instalaciones sí aplican para esta pieza.
Les images peuvent ne pas correspondre exactement au luminaire de la
boîte. Par contre, les directives d’installation s’appliquent au luminaire.
FIGURE 2.
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green or
Bare
Copper
(Ground)