Cut Sheet

SINGLE PIECE STRUT CLAMP FOR CABLE/CONDUIT, 0.34"–0.71" OD, 1/2" EMT

CATALOG NUMBER

SCH8B

CERTIFICATIONS

FEATURES

One-piece cable/conduit clamp with protective boot

No screws or bolts to drop

Requires only a screwdriver or nutdriver for installation

Fits into open side of strut channel

FM® Specification Tested (from 1/2" to 4" of EMT Conduit Size)

PRODUCT ATTRIBUTES

Material: Steel

Finish: Electrogalvanized

Outer Diameter: 0.340" – 0.710"

EMT Conduit Size: 1/2"

Static Load 1: 200 lb

Ultimate Static Load 2: 75 lb

PAGE 1
SINGLE PIECE STRUT CLAMP FOR CABLE/CONDUIT, 0.34"–0.71" OD, 1/2" EMT CATALOG NUMBER SCH8B CERTIFICATIONS FEATURES One-piece cable/conduit clamp with protective boot No screws or bolts to drop Requires only a screwdriver or nutdriver for installation Fits into open side of strut channel FM® Specification Tested (from 1/2" to 4" of EMT Conduit Size) PRODUCT ATTRIBUTES Material: Steel Finish: Electrogalvanized Outer Diameter: 0.340" – 0.
PAGE 2
Ultimate Static Load 3: 50 lb DIAGRAMS WARNING nVent products shall be installed and used only as indicated in nVent's product instruction sheets and training materials. Instruction sheets are available at www.nvent.com and from your nVent customer service representative. Improper installation, misuse, misapplication or other failure to completely follow nVent's instructions and warnings may cause product malfunction, property damage, serious bodily injury and death and/or void your warranty.