Datasheet

56F807 Technical Data Technical Data, Rev. 16
30 Freescale Semiconductor
as a typical circuit board trace capacitance the parallel load capacitance presented to the crystal is 9pF as
determined by the following equation:
This is the value load capacitance that should be used when selecting a crystal and determining the actual
frequency of operation of the crystal oscillator circuit.
Figure 3-7 Connecting to a Crystal Oscillator
3.4.2 Ceramic Resonator
It is also possible to drive the internal oscillator with a ceramic resonator, assuming the overall system
design can tolerate the reduced signal integrity. In Figure 3-8, a typical ceramic resonator circuit is
shown. Refer to supplier’s recommendations when selecting a ceramic resonator and associated
components. The resonator and components should be mounted as close as possible to the EXTAL and
XTAL pins. The internal 56F80x oscillator circuitry is designed to have no external load capacitors
present. As shown in Figure 3-7 no external load capacitors should be used.
Figure 3-8 Connecting a Ceramic Resonator
Note: Freescale recommends only two terminal ceramic resonators vs. three terminal resonators
(which contain an internal bypass capacitor to ground).
CL =
CL1 * CL2
CL1 + CL2
+ Cs =
+ 3 = 6 + 3 = 9pF
12 * 12
12 + 12
Recommended External Crystal
Parameters:
R
z
= 1 to 3 MΩ
f
c
= 8MHz (optimized for 8MHz)
EXTAL XTAL
R
z
f
c
Recommended Ceramic Resonator
Parameters:
R
z
= 1 to 3 MΩ
f
c
= 8MHz (optimized for 8MHz)
EXTAL XTAL
R
z
f
c