User's Manual

UM11016 All information provided in this document is subject to legal disclaimers. © NXP Semiconductors N.V. 2016. All rights reserved.
User manual Rev. 1.0 — 15 June 2016 16 of 24
NXP Semiconductors
UM11016
ZigBee PRO and IEEE802.15.4 JN5169-001-M0x-2 modules
[1] To reach the maximum TX power, 2.8 V is the minimum on V
DD
.
[2] Up to an extra 2.5 dB of attenuation is available if required.
12. Federal Communication Commission Statement
• This equipment has been tested and found to comply with the limits for a Class B
d
igital device, pursuant to Part 15 of the FCC Rules see Ref. 4
. These limits are
d
esigned to provide reasonable protection against harmful interferen
ce in a
residential inst
allation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
m
ay cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to
try to
cor
rect the interference by one of the following measures:
– Reorient or relocate the receiving antenna
– Increase the separation between the equipment and receiver
– Connect the equipment into an outlet on a circuit different from that
to which the
receiver is
connected
– Consult the dealer or an experienced radio/TV technician for help
• OEM integrators instructions
– The OEM integrators are responsible for ensuring that the end-user has no manual
instructions to remove or install module
– The module is limited to installation in mobile or fixed applications, according
to
CFR
47 Part 2.1091(b)
– Separate approval is required for all other operating configurations, including
portable configurations with respect to CFR 47 Part 2.1093 and different antenn
a
co
nfigurations
• User guide mandatory statements
M00
P
o
output power I
DD
= 27.2 mA
[1]
-10-dBm
I
DD
= 23.6 mA
[1]
-8.5-dBm
P
o(cr)
control range output
power
in 6 major steps and then 4 fine steps
[2]
- 42 - dB
M03
P
o
output power I
DD
= 27.2 mA
[1]
-10-dBm
I
DD
= 23.6 mA
[1]
-8.5-dBm
P
o(cr)
control range output
power
in 6 major steps and then 4 fine steps
[2]
- 42 - dB
M06
P
o
output power
[1]
-21-dBm
Table 12. Radio transceiver characteristics: +25 C …continued
V
DD
= 2 V to 3.6 V; unless otherwise specified.
Symbol Parameter Conditions Min Typ Max Unit