User's Manual

UM11016 All information provided in this document is subject to legal disclaimers. © NXP Semiconductors N.V. 2016. All rights reserved.
User manual Rev. 1.0 — 15 June 2016 17 of 24
NXP Semiconductors
UM11016
ZigBee PRO and IEEE802.15.4 JN5169-001-M0x-2 modules
– User's instructions of the host device must contain the following statements in
addition to operation instructions:
* “This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that
may cause undesired operation”
* “Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment”
• FCC RF Exposure requirements
– User's instructions of the host device must contain the following instructions in
addition to operation instructions:
Avoid direct contact to the antenna, or keep it to a 20 cm minimum distance while
using this equipment. This device must not be collocated or operating in
conjunction with another antenna or transmitter.
The J
N5169-001-M03-2 and JN5169-001-M06-2 modules have been designed to
operate with antennas having a maximum gain of 2 dBi. Antennas having a gain greater
than 2 dBi are strictly prohibited for use with these devices. The required antenna
impedance is 50 ohms.
The JN5169-001-M00-2 integrates a printed antenna. The maximum gain of the printed
antenna is 1 dBi.
12.1 FCC end product labelling
The final ‘end product’ should be labelled in a visible area with the following:
“Contains TX FCC ID: XXMJN5169M0V2, XXMJN5169M3V2 or XXMJN5169M6V2” to
reflect the version of the module being used inside the product.
13. Industry Canada statement
To reduce potential radio interference to other users, the antenna type and its gain should
be so chosen that the equivalent isotropic radiated power (e.i.r.p.) is not more than that
permitted for successful communication.
This device complies with Industry Canada
licence-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this
device may not cause interference, and (2) this
device must accept any interference, including
interference that may cause undesired
operation of the device.
This device complies with Industry Canada RF
radiation exposure limits set forth for general
population (uncontrolled exposure). This device
must be installed to provide a separation
distance of at least 20 cm from all persons and
must not be collocated or operating in
conjunction with any other antenna or
transmitter.
Le présent appareil est conforme aux CNR
d’Industrie Canada applicables aux appareils
radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes: (1) il
ne doit pas produire de brouillage, et (2)
l’utilisateur du dispositif doit être prêt a accepter
tout brouillage radioélectrique reçu, même si ce
brouillage est susceptible de compromettre le
fonctionnement du dispositif.
Le présent appareil est conforme aux niveaux
limites d’exigences d’exposition RF aux
personnes définies par Industrie Canada. Cet
appareil doit être installé afin d’offrir une
distance de séparation d’au moins 20 cm avec
l’utilisateur, et ne doit pas être installé à
proximité ou être utilisé en conjonction avec une
autre antenne ou un autre émetteur.