User's Manual
Table Of Contents
- 1. General description
- 2. Features and benefits
- 3. Applications
- 4. Overview
- 5. Marking
- 6. Block diagram
- 7. Pinning information
- 8. Functional description
- 9. Limiting values
- 10. Recommended operating conditions
- 11. Characteristics
- 12. Federal Communication Commission Statement
- 13. Industry Canada statement
- 14. Footprint information for reflow soldering
- 15. Package outline
- 16. Abbreviations
- 17. References
- 18. Legal information
- 19. Tables
- 20. Figures
- 21. Contents
UM11016 All information provided in this document is subject to legal disclaimers. © NXP Semiconductors N.V. 2016. All rights reserved.
User manual Rev. 1.0 — 15 June 2016 18 of 24
NXP Semiconductors
UM11016
ZigBee PRO and IEEE802.15.4 JN5169-001-M0x-2 modules
The J
N5169-001-M03-2 and JN5169-001-M06-2 modules have been designed to
operate with antennas having a maximum gain of 2 dBi. Antennas having a gain
greater than 2 dBi are strictly prohibited for use with these devices. The required
antenna impedance is 50 ohms.
The JN5169-001-M00-2 integrates a printed antenna. The maximum gain of the
printed antenna is 1 dBi.
As long as the above condition is met, further transmitter testing will not be required.
However, the OEM integrator is still responsible for testing their end-product for any
additional compliance requirements required with this module installed (for example,
digital device emissions, PC peripheral requirements, etc).
13.1 Industry Canada end product labelling
For Industry Canada purposes the following should be used:
“Contains Industry Canada ID IC: 8764A-JN5169Mx” (with x = 0 or 3 or 6).
14.
Footprint information for reflow soldering
All modules have the same footprint.
Fig 5. Module PCB footprint
aaa-022825Dimensions in mm
16
2.54
2.54
1.27
3.30
1.5
Ø 1
1