Datasheet

UM10398 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2014. All rights reserved.
User manual Rev. 12.3 — 10 June 2014 227 of 547
NXP Semiconductors
UM10398
Chapter 14: LPC111x/LPC11Cxx SPI0/1 with SSP
14.6.2 SPI/SSP0 Control Register 1
This register controls certain aspects of the operation of the SPI/SSP controller.
Table 209: SPI/SSP Control Register 0 (SSP0CR0 - address 0x4004 0000, SSP1CR0 - address
0x4005 8000) bit description
Bit Symbol Value Description Reset
Value
3:0 DSS Data Size Select. This field controls the number of bits
transferred in each frame. Values 0000-0010 are not
supported and should not be used.
0000
0x3 4-bit transfer
0x4 5-bit transfer
0x5 6-bit transfer
0x6 7-bit transfer
0x7 8-bit transfer
0x8 9-bit transfer
0x9 10-bit transfer
0xA 11-bit transfer
0xB 12-bit transfer
0xC 13-bit transfer
0xD 14-bit transfer
0xE 15-bit transfer
0xF 16-bit transfer
5:4 FRF Frame Format. 00
0x0 SPI
0x1 TI
0x2 Microwire
0x3 This combination is not supported and should not be used.
6 CPOL Clock Out Polarity. This bit is only used in SPI mode. 0
0 SPI controller maintains the bus clock low between frames.
1 SPI controller maintains the bus clock high between frames.
7 CPHA Clock Out Phase. This bit is only used in SPI mode. 0
0 SPI controller captures serial data on the first clock transition
of the frame, that is, the transition away from the inter-frame
state of the clock line.
1 SPI controller captures serial data on the second clock
transition of the frame, that is, the transition back to the
inter-frame state of the clock line.
15:8 SCR Serial Clock Rate. The number of prescaler output clocks per
bit on the bus, minus one. Given that CPSDVSR is the
prescale divider, and the APB clock PCLK clocks the
prescaler, the bit frequency is PCLK / (CPSDVSR  [SCR+1]).
0x00
31:16 - - Reserved -