Datasheet
UM10398 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2014. All rights reserved.
User manual Rev. 12.3 — 10 June 2014 340 of 547
NXP Semiconductors
UM10398
Chapter 18: LPC1100/LPC1100C/LPC1100L series: 16-bit counter/timer
18.7.8 Capture Control Register (TMR16B0CCR and TMR16B1CCR)
The Capture Control Register is used to control whether the Capture Register is loaded
with the value in the Counter/timer when the capture event occurs, and whether an
interrupt is generated by the capture event. Setting both the rising and falling bits at the
same time is a valid configuration, resulting in a capture event for both edges. In the
description below, n represents the Timer number, 0 or 1.
18.7.9 Capture Register (CT16B0CR0 - address 0x4000 C02C and
CT16B1CR0 - address 0x4001 002C)
Each Capture register is associated with a device pin and may be loaded with the
counter/timer value when a specified event occurs on that pin. The settings in the Capture
Control Register register determine whether the capture function is enabled, and whether
a capture event happens on the rising edge of the associated pin, the falling edge, or on
both edges.
Table 288: Match registers (TMR16B0MR0 to 3, addresses 0x4000 C018 to 24 and
TMR16B1MR0 to 3, addresses 0x4001 0018 to 24) bit description
Bit Symbol Description Reset
value
15:0 MATCH Timer counter match value. 0
31:16 - Reserved. -
Table 289. Capture Control Register (TMR16B0CCR - address 0x4000 C028 and TMR16B1CCR - address
0x4001 0028) bit description
Bit Symbol Value Description Reset
value
0 CAP0RE Capture on CT16Bn_CAP0 rising edge: a sequence of 0 then 1 on CT16Bn_CAP0 will
cause CR0 to be loaded with the contents of TC.
0
1 Enabled
0 Disabled
1 CAP0FE Capture on CT16Bn_CAP0 falling edge: a sequence of 1 then 0 on CT16Bn_CAP0 will
cause CR0 to be loaded with the contents of TC.
0
1 Enabled
0 Disabled
2 CAP0I Interrupt on CT16Bn_CAP0 event: a CR0 load due to a CT16Bn_CAP0 event will
generate an interrupt.
0
1 Enabled
0 Disabled
31:3 - - Reserved, user software should not write ones to reserved bits. The value read from a
reserved bit is not defined.
NA
Table 290: Capture registers (TMR16B0CR0, address 0x4000 C02C and TMR16B1CR0,
address 0x4001 002C) bit description
Bit Symbol Description Reset
value
15:0 CAP Timer counter capture value. 0
31:16 - Reserved. -