Datasheet

UM10398 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2014. All rights reserved.
User manual Rev. 12.3 — 10 June 2014 80 of 547
NXP Semiconductors
UM10398
Chapter 7: LPC1100/LPC1100C/LPC1100L series: I/O configuration
7.4.5 IOCON_PIO1_8
7.4.6 IOCON_PIO0_2
Table 62. IOCON_PIO1_8 register (IOCON_PIO1_8, address 0x4004 4014) bit description
Bit Symbol Value Description Reset
value
2:0 FUNC Selects pin function. All other values are reserved. 000
0x0 Selects function PIO1_8.
0x1 Selects function CT16B1_CAP0.
4:3 MODE Selects function mode (on-chip pull-up/pull-down resistor
control).
10
0x0 Inactive (no pull-down/pull-up resistor enabled).
0x1 Pull-down resistor enabled.
0x2 Pull-up resistor enabled.
0x3 Repeater mode.
5 HYS Hysteresis. 0
0 Disable.
1 Enable.
9:6 - - Reserved 0011
10 OD Selects pseudo open-drain mode. See Section 7.1
for part
specific details.
0
0 Standard GPIO output
1 Open-drain output
31:11 - - Reserved -
Table 63. IOCON_PIO0_2 register (IOCON_PIO0_2, address 0x4004 401C) bit description
Bit Symbol Value Description Reset
value
2:0 FUNC Selects pin function. All other values are reserved. 000
0x0 Selects function PIO0_2.
0x1 Selects function SSEL0.
0x2 Selects function CT16B0_CAP0.
4:3 MODE Selects function mode (on-chip pull-up/pull-down resistor
control).
10
0x0 Inactive (no pull-down/pull-up resistor enabled).
0x1 Pull-down resistor enabled.
0x2 Pull-up resistor enabled.
0x3 Repeater mode.
5 HYS Hysteresis. 0
0 Disable.
1 Enable.
9:6 - - Reserved 0011