Instructions / Assembly

16
CARE & MAINTENANCE
WARNING
FOR YOUR SAFETY
• Do NO
at least 45 minutes after use.
• Burner is hot to the touch.
• Allow burner to cool before
touching.
perform the following maintenance activities on a regular basis:
cleaning agents.
2. While cleaning your unit, be sure to keep the area around the burner and
control compartment dry at all times. Do not submerge the control valve
assembly. If the gas control is submerged in water, do NOT use it. It must
covering with a cover.
A. Keep the appliance area clear and free from combustible materials,
C. Keep the ventilation opening(s) of the cylinder enclosure free and clear
from debris.
air passageways clean. Signs of possible blockage include:
• Fire pit does NOT reach the desired temperature.
• Fire pit glow is excessively uneven.
• Fire pit makes popping noise.
burner holes by using a heavy-duty pipe cleaner. Compressed air
may help clear away smaller particles.
warm soapy water if any carbon deposits develop.
Note: in a salt-air environment (such as near an ocean), corrosion occurs more
quickly than usual. Frequently check for corroded areas and repair promptly.
SERVICE:
repair gas passages and associated
components.
STORAGE:
Between uses:
• Turn control knob OFF.
• Disconnect LP source.
from direct contact with
inclement weather (such
as rain, sleet, hail, snow, dust
and debris).
protect exterior surfaces and
to help prevent build-up in air
passages.
During periods of extended
inactivity or when transporting:
• Turn control knob OFF.
• Disconnect LP source and move
to a secure, well-ventilated
location outdoors.
from direct contact with
inclement weather (such as
rain, sleet, hail, snow dust and
debris).
protect exterior surfaces and
to help prevent build-up in
air passages. Never leave LP
cylinder exposed to direct
sunlight or excessive heat.
Note:
cool before covering.
Caution: Always allow fire pit to
cool before attempting service.