Inc Operations Guide Printer

ManualsBrandsOce North America ManualsPrinterOP14

2. Set-up

2-3 Network (TCP/IP) settings

When the optional Network Card is installed and this machine is to

be used as a network printer, it is necessary to set the corresponding

IP address for the printer.

Notes

• The IP address that should be registered here will differ depending

upon your network environment. Check with your network

administrator BEFORE performing this setting.

• If you are using a DHCP server to automatically configure the IP

address, this setting will not be necessary because DHCP server

configuration is already enabled as the factory default setting.

* To cancel the setting midway through it, press the Stop/Reset key.

Press the Printer key. The machine will switch to the printer

mode and “P00” will appear in the copy quality/magnification

display.

Use the (+) and (–) keys to select “23” and then press the

Enter key. The display will change to “P23” (the TCP/IP ON/

OFF setting).

Use the (+) and (–) keys to select “1” (On) and then press

the Enter key. The selected setting will flash twice and will

then be registered.

Use the (+) and (–) keys to select “24” and then press the

Enter key. The display will change to “P24” (the DHCP ON/

OFF setting).

Use the (+) and (–) keys to select “2” (Off) and then press

the Enter key. The selected setting will flash twice and will

then be registered.

Use the (+) and (–) keys to select “25” and then press the

Enter key. The display will change to “P25” (the IP address

setting).

The (+) and (–) keys will be used to select the 12-digit IP

address in blocks of 3 digits each:

First, enter the appropriate 3 digits for the first block and

then press the Enter key. Repeat this same procedure for

the 3 remaining blocks of the address (4 blocks in all). Once

the Enter key is pressed for the final 3-digit block, the

display will flash twice and the IP address will be registered.

Use the (+) and (–) keys to select “26” and then press the

Enter key. The display will change to “P26” (the Subnet

Mask setting). Enter the 12-digit Subnet Mask using the

same procedure that you did for entering the IP address.

Use the (+) and (–) keys to select “27” and then press the

Enter key. The display will change to “P27” (the Gateway

address setting). Enter the 12-digit Gateway address using

the same procedure that you did for entering the IP address.

Once you are finished making all of the network settings,

press the Printer key. The machine will switch back to the

copier mode.