Product Manual

ManualsBrandsOceanLED ManualsBoating & MarineM6 Gen2 Underwater Mast Light

Ultra White

011203W

Warm White

011204WW

The new M6 Gen2 Mast Series light from

OceanLED is 50% brighter than its previous

model with an improved design. The narrow

beam angle helps focus the powerful LEDs,

enhancing the natural beauty of your vessel,

making It perfect for illuminating your rigging.

Suitable for aluminium, steel and composite

rigs on all sizes of boats ranging from

sportﬁshing to larger yachts.

Easy to install, sturdy, weatherproof and

exceptionally easy to maintain. Ultra low

power draw, reverse polarity protection

• Always ﬁnd your boat when moored

• Eliminate poorly lit areas

• Enhance the lines of your boat at night

• Circular beam gives large deck footprint

• 10 meter cable for running down masts

• Same footprint as earlier models

• Chemically resistant polymer

The M6 Gen2 Mast Series Light from OceanLED is perfect for

illuminating your rigging.

COLOUR

PART#

OceanLED SPEC SHEET / Mast Series / M6 Gen2 / 270118 / v9.0 / Speciﬁcations are subject to change without notice. Trademarks are the property of OceanLED.

KEY

FEATURES

Up To 660

Fixture Lumens

38°

Top Beam

38°

Side Beam

Circular

Beam

M6 GEN2 MAST SERIES

SURFACE MOUNT

Summary of content (2 pages)

PAGE 1
M 6 G E N 2 MAST SERIES S U R FAC E M O U N T The M6 Gen2 Mast Series Light from OceanLED is perfect for illuminating your rigging. KEY FEATURES Up To 660 Fixture Lumens 38° Top Beam COLOUR PART# Ultra White 011203W Warm White 011204WW The new M6 Gen2 Mast Series light from OceanLED is 50% brighter than its previous model with an improved design. The narrow beam angle helps focus the powerful LEDs, enhancing the natural beauty of your vessel, making It perfect for illuminating your rigging.
PAGE 2
M 6 Ge n2 FOCUSED, NARROW BEAM ANGLE 38° focused, narrow beam to illuminate your spreaders, beams and rigging. BOX CONTENTS M6 Light and Cable COMPACT AND SIMPLE DESIGN Made from a chemically resistant optical polymer with a built in driver. Slender design is perfect for mounting on narrow spreaders and beams. In-line Fuse Kit Mounting Screws Quick Install Guide ACCESSORIES SIMPLE TO INSTALL Installation needs only a small, 1/2” hole in the hull to feed the cable through and 2 screws to hold in place.