Product Manual

1010

CHAPTER

THREE

Chapter 3: Operation

3.1 - Single Colour Strobe

To enter strobe mode, toggle the power on and o quickly twice, then back on. They should now strobe in

a pseudo-random pattern. The lights can be reset from strobe mode after 20 seconds of use. Simply turn

o then back on again.

3.2 - Dual Colour Operation

The Dual colour change has seven modes of operation;

1. Single colour white – this mode is entered when the light is ﬁrst turned on.

2. Single colour blue

3. Fade - Fade between white and blue.

4. Random white strobe -

5. Random blue strobe -

6. Alternate blue/white strobe

7. Dual colour (blue and white both on)

To cycle between the above modes, turn o the light for less than 1 second, then back on again.

PLEASE NOTE: Fade mode is not guaranteed to stay in sync between lights over time.

3.3 - Sport Dual Colour Conﬁguration Mode

Description: Enables selection of either white or blue colour as default at power up.

To enter conﬁguration mode:

1. Turn on light(s)

2. Wait around 1 second (or until light(s) illuminate)

3. Turn o light(s)

4. Wait for a minimum of 5 seconds then turn light(s) back on again.

5. Repeat steps 2-4 another 4 times. (If the light changes mode on re power up then the light has not

been turned o for long enough in step 4)

6. On the 5th power up, the light(s) should enter the conﬁguration mode – this will be conﬁrmed with

a sequence of ﬁve blue/white ﬂashes followed by a steady white (the steady colour indicates the

default start up colour).

Setting the default start up colour:

1. Once the conﬁguration mode has been entered (see above). Toggling o the power and back on

again quickly (as in a normal mode change) will toggle between the default start-up colours (blue &

white). This is indicated by the colour displayed after the blue/white ﬂash sequence.

2. To save the selected state simply turn o the light(s) when the required start up colour is displayed

and wait for 5-10 seconds.

3. The light(s) should now be conﬁgured to start with the selected colour as default.