Product Manual

3.4 Sport Multi Colour control with DC switch operation:

The Sport Multi Colour has three modes of operation, single colour mode, cycle / programing mode, and

strobe mode:

1. Single colour mode – this mode is entered when the light is ﬁrst turned on. The light will be a single

colour, either a default white, or a previously selected colour.

2. Strobe mode – to enter this mode, turn o the light for less than 1 second, then back on again. The

light will ﬂash in a pseudo-random pattern - the colour will be the same as that in single colour

mode.

3. Cycle / Program mode, to enter this toggle the power to the unit o twice for less than 1 second

each time. The light will then slowly cycle and fade through the colour spectrum (see diagram

below for cycle order). It can be left in cycling if required, or alternatively, once the light shows the

desired colour this can be stored by switching the light o for more than 2 seconds. When the light

is switched back on it will be back in single colour mode, displaying the previously selected colour.

NOTE: If during the above operations, one or more lights connected go out of sync, simply switch o the

lights for more than 2 seconds, then re-enter cycle mode to re-select the colour.

3.5 Sport Multi Colour cycle:

Blue ----> White ---–> Green ---–> Blue ---–> Red ---–> Green (then repeat).