Product Manual

66
2
CHAPTER
TWO
Chapter 2: Installation
Note: OceanLED makes every eort to protect our marine and fresh water environment as
well as our natural resources. Please take care to keep packaging away from and out of the
water by ensuring loose packaging materials are secured and not susceptible to being blown
into the water. Please recycle all packaging materials as the sustainability of our environment is everyone's
responsibility.
WARNINGS:
• Never use power tools to secure your lights; hand tighten only.
• We recommend you use screws provided. If alternative screws are used, do not use counter sunk or non flat
shoulder screws to secure your lights to the hull.
• OceanLED recommends dry fitting all products. When installing, be sure that the light fits the area and se-
cures to the hull using the appropriate hardware before applying any sealant.
• Light is for thru-hull mounting only. Cable and connections exposed to underwater submersion will not be
covered by warranty!
• There are several dierent hull types. Most are either solid GRP or cored. Be sure you follow the correct
procedures for the hull you are preparing since all require dierent preparation methods. We will cover
the most common type below. If in doubt please contact your local OceanLED representative or the
boat manufacturer for assistance.
• Please check all components prior to installation. If there is any damage to connectors, cables, and/
or any other component, please notify OceanLED BEFORE installation. Failure to notify OceanLED of
damage in transit prior to installation will lead to violation of warranty.
• Light is for mounting directly to a flat surface on the hull, with the cable passing through a 1/2"
(12.5mm) hole in the hull. Do not submerse your cable in water; cable and connections exposed to
underwater submersion will not be covered by warranty. Mounting the light in any other configuration,
other than those described in this guide, will invalidate its warranty.
2.1 Preparing a fiberglass hull
TIP: Always wear safety goggles and a dust mask.
1. Drill a 3mm / 1/8” pilot hole square to mounting surface from inside the hull if possible. If there is
a rib, strut, or other hull irregularity near the selected mounting location, this will need to be taken
into account in the planning phase and the location adjusted accordingly, or the obstruction safely
removed or modified.
2. Using a suitable drill, make a 1/2" (12.5mm) hole. Ensure the light will fit flush and will be square to
the mounting surface.
3. Sand the area around the hole using a heavy grit sandpaper to remove the previous bottom paint
and to ensure that the sealant will adhere properly to the hull. If there is any petroleum residue