Installation Guide

22
Drill
Phillips Screwdriver
Gloves
Roofing Sealant
Hole Cutting Template
Formable Main Flashing
(9) 2” Screws
(9) 3/4 Washers
TOOLS & PARTS
Slide the upper portion of the main flashing under
the metal panel through the slit. Be sure to align the
flashing directly over the hole.
1
Be sure to dab sealant on all screw heads to ensure a
leak-free installation.
IMPORTANT
“Dry-t form” the lower side of the ashing to
conform to the panel ridges.
2
Once flashing is formed over the panel ridges to your
satisfaction, apply a generous bead of sealant to the
underside of the lower flashing section.
3
Press formed flashing down around roofing material.
4
Attach with (9) 2” screws and 3/4 diameter washers
in an evenly spaced circular pattern around the 10” or
14” hole. The circular pattern should be 21” diameter
on the 10” unit and 24” diameter on the 14” unit.
Add additional 2” pan head screws as needed to
secure edge of flashing.
Refer back to Section 4c for complete installation.
5
5
1
2
3
4
Position & Secure Flashing
Section-12c
Metal Roofing Installation