Installation Guide

BRISA

Retractable Screen Door

Screen Replacement Instructions

STEP 1

Remove the existing unit from door frame. To prevent

the retractable screen from falling, leave one of the top

screws in place until you are ready to remove the unit.

STEP 2

Lay the unit down ﬂat on a clean surface.

STEP 3

Release the tracks and remove the screen housing end caps

(2 long outside screws only). Keep parts and new screen in

same position after removal to ensure proper placement.

Screen may make noise when tension is released.

STEP 4

Take off the slider bar end caps and remove the old screen

from the housing unit. Some models may have a screw

inserted into the slider bar end cap that will require removal.

Assembly process

These instructions outline the step-by-step process to install a replacement screen for retractable screen doors.

Before starting, review all instructions and become familiar with them.

Patent Pending

PAGE 1
BRISA Retractable Screen Door Screen Replacement Instructions Assembly process These instructions outline the step-by-step process to install a replacement screen for retractable screen doors. Before starting, review all instructions and become familiar with them. STEP 1 STEP 2 Remove the existing unit from door frame. To prevent the retractable screen from falling, leave one of the top screws in place until you are ready to remove the unit. Lay the unit down flat on a clean surface.
PAGE 2
STEP 5 STEP 6 Insert the new screen, making sure to thread the screen spline through the housing and slider bar channels. Use caution when inserting so that the screen doesn’t catch on metal edges. Reattach the slider bar end caps. Re-insert the screw if one was removed. STEP 7 STEP 8 Reattach both screen housing end caps starting with the side with the long black tube. Align black tube with ridges inside the screen. Make sure slider bar is inside the end caps before attaching.