Operation Manual

Menu functions > 26
Network
Setup
(cont.)
SNMP Enable
Disable
Sets Enable/Disable of SNMP.
Enable: SNMP is available.
Disable: SNMP is not available.
TCP/IP or NetWare should be enabled.
Network
Scale
Normal
Small
When Normal is selected, the network can work
effectively even when it is connected to a HUB that has a
spanning tree feature. However, printer start up time gets
longer when computers are connected with two or three
small LANs.
When Small is selected, computers can cover from two or
three small LANs to a large LAN, but may not work
effectively when the network is connected to a HUB with a
spanning tree feature.
Hub Link
Setting
Auto Negotiate
100Base-TX Full
100Base-TX Half
10Base-T Full
10Base-T Half
Sets a method to link to a HUB. When Auto is set, a
connection method to a HUB is selected automatically.
Factory
Defaults?
Execute Specifies whether to initialize the network factory default
settings for the Network.
Print Setup Personality Auto
PostScript
PCL
IBM PPR
EPSON FX
Selects a printer language.
Copies 1- 999 Selects the default number of copies.
Duplex On/Off Specifies Duplex print (option) if a Duplex unit is installed
and enabled
Binding Long Edge
Short Edge
Specifies Binding in duplex printing (if a Duplex unit is
installed and enabled)
Media Check Enable
Disable
Sets whether the printer checks the matching of printed
data size and that of the tray. Only standard sizes are
checked.
Resolution 600dpi
600x1200dpi
600dpi multi-
level.
Sets default resolution.
Ton er S av e
Mode
On/Off This function works effectively only if the data input is
color RGB data. This setting is valid in PS and PCL, but
does not take effect in the following cases.
(1) PS: If Color Matching is set OFF.
(2) PS: If any setting other than ASIC Color Matching is
set.
(3) PS: CMYK data when Ink Simulation Mode is used
(valid in any other cases except Case (1) and Case (2)
above as long as data is RGB).
(4) PCL binary data (Color/Monochrome).
ITEM SETTINGS EXPLANATION