Full Product Manual

www.napoleongrills.com
20
EN
BIP500RB BUILT-IN INSTRUCTIONS
This grill is designed for masonry, NON-COMBUSTIBLE enclosures only, and must be installed and serviced by a
qualied installer to local codes.
1. Aach the side mounng brackets to each side of the grill using (4) 1/4 - 20 x 7/8” screws (N570-0087). Pre-installed
at factory.
2. Lay the rear trim piece across the back of the opening. To keep it in place, a dab of silicone may be applied to each
wing of the rear trim.
3. Lower the unit in place, the wings on the rear trim should be under the side mounng brackets. Connect the ex
supply line to the ng at the end of the manifold.
4. The enre installaon must be leak tested before operang the unit.
N570-0087 (1/4” -20 X 7/8”)
(Pre-installed at factory.)
x4
APPLY A DAB OF SILICONE
TO EACH FLANGE TO
SECURE IN PLACE.