User's Manual

ManualsBrandsOlicom ManualsNetwork RouterOlicom Broadband Wireless Router (AP)

Broadband Wireless Router (AP)

Quick Started Guide

Introduction

Congratulations on your choosing of this

Broadband Wireless Router (AP) with 4-port switch and

access point that extend your existing broadband DSL/Cable connection. The 802.11b access point

allows PC’s with wireless cards connect together, while the high performance 4-port switch that

expand your local network for small office. Also the feature-rich routing functions are seamlessly

integrated to broadband service for existing home or office users. Now users can enjoy various

bandwidth-consuming applications via this Broadband Wireless Router (AP).

ADSL /ATU-R

Remote

WAN

Internet

Connection Figure

Summary of content (5 pages)

PAGE 1
Broadband Wireless Router (AP) Quick Started Guide Introduction Congratulations on your choosing of this Broadband Wireless Router (AP) with 4-port switch and access point that extend your existing broadband DSL/Cable connection. The 802.11b access point allows PC’s with wireless cards connect together, while the high performance 4-port switch that expand your local network for small office.
PAGE 2
Packet Contents • • • • Broadband Wireless Router (AP) Power Adapter RJ-45 Ethernet Cable Quick Started Guide and User Manual CD Hardware Front panel The following illustration shows the front panel of the Broadband Wireless Router (AP): 1. When link is established, the LED is On. 2. When the device is transferring data, the LED is Blinking. Rear Panel The following figure illustrates the rear panel of your Broadband Wireless Router (AP). - PWR: Power Switch.
PAGE 3
Connecting the Broadband Wireless Router (AP) 1 Connecting to the WAN port. Connect the Ethernet cable with your xDSL/ATU-R to the 10Base-T Ethernet WAN port on your Broadband Wireless Router (AP). Note: 1. The attached xDSL/ATU-R must provide a standard 10Base-T Ethernet connection. Please use the Ethernet cable provided by your ISP or any other standard 10Base-T Ethernet cable. 2.
PAGE 4
Basic Configuration On Ethernet Client Step 1 Choose a client PC and configure it to get a dynamic IP from the Broadband Wireless Router (AP). Step 2 Start up your browser and type 192.168.0.1 as the address to enter the web-based manager. Step 3 Enter the default username and password. Both values are admin (small letters). Step 4 Go to Basic > WAN Setting to finish basic configuration. From the drop-down list select your WAN connection type.
PAGE 5
Important Notice 1. If you are using PPPoE, the default connection type is Dial On Demand and the Max Idle Time is 10 min. You may adjust the max idle time as required. 2. As the default SSID for wireless connection is “IEEE 802.11 LAN”, it is recommended to customize your SSID value. 3. To prevent your Broadband Wireless Router (AP) from being accessed by unauthorized intruders, it is suggested to enable WEP encryption. 4.