User's Manual

Connecting the Broadband Wireless Router (AP)

1 Connecting to the WAN port.

Connect the Ethernet cable with your xDSL/ATU-R to the 10Base-T Ethernet WAN

port on your Broadband Wireless Router (AP).

Note:

1. The attached xDSL/ATU-R must provide a standard 10Base-T Ethernet connection.

Please use the Ethernet cable provided by your ISP or any other standard 10Base-T

Ethernet cable.

2. The Ethernet cable supplied by your ISP for connecting to your xDSL/ATU-R may be

an Ethernet crossover cable or a straight-through cable. It is important to use the cable

provided by your ISP to connect the modem to your Broadband Wireless Router (AP).

2 Connecting to the LAN port L1/L2/L3/L4.

Attach one end of the Ethernet cable with RJ-45 connector to the AV port of your

Broadband Wireless Router (AP).

The Broadband Wireless Router (AP) incorporates a four-port switch for connection

to your local Ethernet network. The Ethernet ports are capable of operation at either

10Mbps (10Base-T) or 100Mbps (100Base-Tx), depending on the Ethernet interface

of the attached PC, hub or switch. For any connection which will operate at 100 Mbps,

you must use a category 5 rated cable, such as the Ethernet cable included with the

Broadband Wireless Router (AP).

3 Preparing your wireless station.

You need to check the setting of wireless client stations to match the default settings

of the Broadband Wireless Router (AP):

1. The default SSID: IEEE 802.11 LAN.

2. WEP encryption is disabled. Authentication Type is Open Key (or Open

System according to your Wireless LAN Card).

3. Use Infrastructure connection mode.

4 Connecting the power adapter .

Connect the supplied power adapter to the 12VDC port of your Broadband Wireless

Router (AP), and the other end to a power outlet.